MVSFORUMS.com

[amit4u79]

Hi All,

I just searched the forum and found that CICS commands can be issued through a JCL using IEFBR14 and then issuing "// F CICS-NAME....", but I have to issue some Operator commands like "D R,R,SYS=sysname" or say "$D A,J" in general any operator command through JCL. When I used the JCL below, it did not serve the purpose:

// JOB CARD
//STEP1 EXEC PGM=IEFBR14
// D R,R,SYS=sysname(substituted the sysname here)
//*

I checked the syslog and the command does not seem to be issued. FYI, I have access to issue Operator command. Am I missing something here ??

Kindly help.

Regards,
- Amit.
_________________
I did not fail; I have found 10,000 ways that would not work - Albert Einstein.

[ofer71]

Do you get any error/information messages ?

O.
________
TN

[Bill Dennis]

The recommended method is now a JCL card like this:

//anyname COMMAND 'your command here '

NOTE: Commands via JCL can be disabled by the SYSPROGs.
_________________
Regards,
Bill Dennis

Disclaimer: My comments on this foorum are my own and do not represent the opinions or suggestions of any other person or business entity.

[amit4u79]

Hi Bill, thanks for the reply but when I use the below jcl it gives me a max cc of 0 but the command is not issued at the console:

//AOAJIXXX JOB (XXXXXX),'FILE REPORT',
// MSGCLASS=O,NOTIFY=&SYSUID
//STEP2 COMMAND 'D R,R,SYS=SS09'
//STEP1 EXEC PGM=IEFBR14
//*

Kindly let me know what I am missing here.

Thanks for your replies. I dont know why is this not working for me.
_________________
I did not fail; I have found 10,000 ways that would not work - Albert Einstein.

[tcb]

amit4u79,
try to run following jcl: