MVSFORUMS.com

Mike Nitz

I've written many execs that are meant to be utilized in 3.4, but the execs could be MUCH more usefull if I was able to pull the volser from the 3.4 list itself. Does anyone know of any way to get this info??

Terry_Heinze · Posted: Fri May 09, 2008 3:39 pm Post subject:

If you've saved the list to a data set, the volser should be one of the columns. If not, scroll to the right and it should be there. No need to scroll if you've chosen your "preferred" view appropriately. If you're talking tapes (you didn't specify), you'll need a tape management system such as CA-1 to see the volser. Come to think of it, even if it's tape, the volser should show up on a 3.4 display.
_________________
....Terry

semigeezer · Posted: Fri May 09, 2008 7:53 pm Post subject:

ZDLVOL
_________________
New members are encouraged to read the How To Ask Questions The Smart Way FAQ at http://www.catb.org/~esr/faqs/smart-questions.html.

Mike Nitz · Posted: Sun May 11, 2008 2:22 pm Post subject:

ZDLVOL works like a champ!!!! Thanks!

prasanth_thavva · Beginner Joined: 14 May 2006 Posts: 40 Topics: 18

Hi,

Its not available at my shop , can any body give alternate command plz ?
_________________
Thanks&Regards
Prasanth Thavva

Nic Clouston · Posted: Thu May 15, 2008 3:55 pm Post subject:

ZDLVOL is not a command - it is an ISPF variable name. If you read the link given by semigeezer you would know.
_________________
Utility and Program control cards are NOT, repeat NOT, JCL.