MVSFORUMS.com

kingo · Posted: Thu May 10, 2007 4:58 am Post subject: E37 and utility id missing

Hi,

My job has abended with E37 saying that utility id is missing.How to fix it?

Regds,
Kingo
_________________
IF YOU ARE NOT FOCUSSED ON GOAL ALL YOU SEE IS OBSTACLE.

dbzTHEdinosauer · Posted: Thu May 10, 2007 5:10 am Post subject:

be nice to know what you were running. JCL for the step involved: JE1,2,3 and sysout.
have you tried IBM LookAt Site? this is the response from E37 and after reading about E37, I then looked here: which is your ultimate goal
_________________
Dick Brenholtz
American living in Varel, Germany

kolusu · Posted: Thu May 10, 2007 5:13 am Post subject:

kingo,

Post detailed information on what you're trying to accomplish. Do not make people guess what you mean. This will give you a much better chance of getting a good answer to your question.

You did not post any error messages nor told us what you are trying to do. How do you expect us to help you?

Kolusu
_________________
Kolusu
www.linkedin.com/in/kolusu

kingo · Posted: Thu May 10, 2007 5:36 am Post subject:

I am trying to load.

Regds,
Kingo
_________________
IF YOU ARE NOT FOCUSSED ON GOAL ALL YOU SEE IS OBSTACLE.

kingo · Posted: Thu May 10, 2007 5:42 am Post subject:

Sorry for that typo error thats unload

Thanks,
Kingo
_________________
IF YOU ARE NOT FOCUSSED ON GOAL ALL YOU SEE IS OBSTACLE.

Nic Clouston · Posted: Thu May 10, 2007 5:45 am Post subject:

unload what? using what? - and have you read up about the error message in the manuals as indicated by Dick? what have you tried to do to resolve the problem?
_________________
Utility and Program control cards are NOT, repeat NOT, JCL.

kolusu · Posted: Thu May 10, 2007 5:46 am Post subject:

kingo,

good going. No wonder all your topics run wild with atleast 15 posts in each. Twisted Evil

_________________
Kolusu
www.linkedin.com/in/kolusu

kingo · Posted: Thu May 10, 2007 6:00 am Post subject:

ABEND E37000 AT xxxxxx DATA AT PSW=somechars

is the message i get.

Regds,
Kingo
_________________
IF YOU ARE NOT FOCUSSED ON GOAL ALL YOU SEE IS OBSTACLE.

Nic Clouston · Posted: Thu May 10, 2007 6:09 am Post subject:

You may be getting that but you should be getting a message along the lines of SE37-xx. The xx relates to what is in the manual under rc and you base your actions on that
_________________
Utility and Program control cards are NOT, repeat NOT, JCL.

dbzTHEdinosauer · Posted: Thu May 10, 2007 6:16 am Post subject:

kingo,

Nic Clouston · Posted: Thu May 10, 2007 7:05 am Post subject:

that is - the space attributes after execution as provided by e.g. 3.2 or 3.4 - not what is in your jcl
_________________
Utility and Program control cards are NOT, repeat NOT, JCL.