MVSFORUMS.com

[MainframeJoe]

Hi all, here is my question.

I want to be able to have a page # at the top of each page on the report, but i want the page # to lets say start in a specific position, and not let EZT do it for me.

Is there a way to do this?

Thanks

[kolusu]

MainframeJoe,

try this

[MainframeJoe]

This is what i have but i have an error:
QUALIFICATION REQUIRED - PAGE-COUNT
Is this a counter i need to increment?

Thanks for the help!

CODE:

[kolusu]

[MainframeJoe]

Changing RPT1 to L1-REPORT is not going to fix it. RPT1 is the OUTFILE in which i want the report to be sent to.
The job runs if i remove the PAGE-COUNT and let EZT add the counter to the report.

Any other suggestions?

Thanks

[kolusu]

MainframeJoe,

I don't understand . run the following job and see how the report works

[MainframeJoe]

Here is my error message.

Is PAGE-COUNT a counter that i need to increment? Or is this like a KEY word ?


REPORT L1-REPORT SPACE 1 PRINTER RPT1 SKIP 1 NOADJUST NODATE +
SUMSPACE 3 TALLYSIZE 6 NOPAGE
SEQUENCE ACCT
CONTROL
TITLE 1 'RUN DATE :' SYSDATE +
COL 80 'PAGE : ' PAGE-COUNT
*******B039 QUALIFICATION REQUIRED - PAGE-COUNT
TITLE 2 'RUN TIME :' SYSTIME +

[MainframeJoe]

I guess no one has the answer

[kolusu]

[MainframeJoe]

You job should run no different then mine.
If i remove the word PAGE-COUNT my job runs without any problems, so even if i copy your job it will do the same and give me an error.
From our online documentation i think we are running V6.4. But i would not really know because i do not work in our data center.

[kolusu]

[MainframeJoe]

Again my job runs fine without the word PAGE-COUNT so i cannot see why yours would run any different that makes no sense.

[kolusu]