MVSFORUMS.com

dsonsamuel · Beginner Joined: 25 Mar 2004 Posts: 26 Topics: 16

Hi,
I did some changes to my MPP program and compiled it. But I am not getting the changes reflected in the screen. I have double checked that I am using the correct load library. Is there anything else I should do to ensure ?

Interestingly, the changes to the MFS are getting reflected and the program and copybook changes are not reflected.!!!!!!!!

regards,
Dson.

Bithead · Posted: Fri Feb 03, 2006 2:58 pm Post subject:

You need to swap the active format libraries (see Online Change Utility in the IMS Administrators Guide - TM) or use the TFORMAT library if enabled in your shop.

Your shop may also reload the libraries when the IMS subsystem is restarted.

dsonsamuel · Beginner Joined: 25 Mar 2004 Posts: 26 Topics: 16

Thanks...But do u mean that i need to use /MODIFY COMMIT every time i compile my MPP pgm for changes?

Also.....but why does my MFS changes are reflected even before swapping the active libraries?

Bithead · Posted: Fri Feb 03, 2006 3:32 pm Post subject:

Check to see if your program is in the pre-load list (DFSMPL*). If not, it may still be loaded if activity is low. Try recycling the MPP region.

CaptObvious · Beginner Joined: 01 Feb 2006 Posts: 19 Topics: 1

Actually, if you're using the TFORMAT library, that would explain why the MFS changes are being shown, but the MPP changes are not. I think you're looking at an ACBGEN and online change to swap active ACBLIBs to get your MPP changes reflected.