MVSFORUMS.com

tcurrier · Intermediate Joined: 10 Feb 2006 Posts: 188 Topics: 68

Not sure if 'Utilities' is the correct category for a Changeman question, but here goes:

I want to change the job card on the batch Changeman JCL to add the 'print lines' positional parameter, e.g.

//MYJOB JOB ('MYNAME',999,999),MSGCLASS=O

But after the job is submitted and I come back into the panel later, my change wasn't persisted... It reverts back to whatever the default job statement information is.

Anyone know how to 'persist' a change to the job statement information?

Thanks.

tcurrier · Intermediate Joined: 10 Feb 2006 Posts: 188 Topics: 68

OK... here's what I found out later.....

The 'problem' was only happening on the TSO CMNDDIO panel...

If I submit a batch COMPILE and change the job statement information, it persists...

Then when I go into either the COMPILE or CMNDDIO panel, the change is in effect...

kolusu · Posted: Mon Aug 29, 2011 6:31 pm Post subject:

tcurrier,

Try making changes and then logoff and then logback to see if it saved the last change.

Kolusu

tcurrier · Intermediate Joined: 10 Feb 2006 Posts: 188 Topics: 68

Nope, didn't work.... Sad

Anuj Dhawan · Posted: Wed Aug 31, 2011 4:14 am Post subject:

tcurrier · Intermediate Joined: 10 Feb 2006 Posts: 188 Topics: 68

Thanks, Anuj.. it didn't occur me that CMNDDIO might be a local command and not native to Changeman. I'll check out that angle....

Anuj Dhawan · Posted: Fri Sep 02, 2011 7:10 am Post subject:

Good Luck... Smile

.
_________________
Regards,
Anuj