MVSFORUMS.com

arvibala · Beginner Joined: 12 Feb 2008 Posts: 142 Topics: 67

Hi

When our Module is run, we are getting SOC7 abend for second record. To confirm its not data issue, I swapped the records and ran still it abends for the second record.

kolusu · Posted: Wed Nov 03, 2010 12:05 pm Post subject:

arvibala,

Are any of the passed values comp-3 fields? Also is the subroutine in the initial state for each call?

Check these 2 links

http://www.mvsforums.com/helpboards/viewtopic.php?t=3788&highlight=initial+subroutine

http://www.mvsforums.com/helpboards/viewtopic.php?t=1477&highlight=initial+subroutine

Kolusu

dbzTHEdinosauer · Posted: Wed Nov 03, 2010 12:12 pm Post subject:

Arvind,
go to offset +00001DB4 in program STYHIVFD (look in compile listing)

and see what instruction is being executed.

since it is a SOC7, you know that you have a problem with a numeric field.
thus you comment,

papadi · Supermod Joined: 20 Oct 2009 Posts: 594 Topics: 1

Look in the code for a numeric variable that has not been given a "value".

If such a field is added to, subtracted from, etc, or compared to some other numeric value, a 0c7 can happen.

Check to make sure the calling code and the called code have the same definition of the "using" parameters.
_________________
All the best,

di

arvibala · Beginner Joined: 12 Feb 2008 Posts: 142 Topics: 67

As I posted before the Abend was between END-PERFORM and 2300-EXIT based on OFFSET value ...

arvibala · Beginner Joined: 12 Feb 2008 Posts: 142 Topics: 67

I found the issue ... Variable XSTYIW8C-REC-CNTR is not being initialized.

Before the perform a DB2 module STYHIW8C ( only for first record) is being called where this variable is getting initialized. But that call was failing because of -805 (Package Not Found) and we failed to capture that so when the second record was read it directly came to the perform and since it was not initialized ... it failed with SOC7

Thanks All
_________________
Arvind
"You can make a difference with your smile. Have that with you always"

dbzTHEdinosauer · Posted: Thu Nov 04, 2010 7:29 am Post subject:

apparently, you are not checking sqlcodes.
as you add this very importent logic - checking sqlcodes
you should also add a CALL to DSNTIAR,
this post by JSHARON1248 is an excellent example of implementation.
_________________
Dick Brenholtz
American living in Varel, Germany

arvibala · Beginner Joined: 12 Feb 2008 Posts: 142 Topics: 67

Thanks Bren
_________________
Arvind
"You can make a difference with your smile. Have that with you always"