MVSFORUMS.com

rahul780 · Beginner Joined: 04 Jan 2008 Posts: 10 Topics: 9

hi all,

in my jcl i am giving TYPERUN=HOLD and hold this job from execution now i want to release it ,i know that by typing A in spool area in front of holed job that job release but this method not support in our id's so can there is an alternative

regards
rahul

warp5 · Posted: Wed Mar 05, 2008 3:18 am Post subject:

You can use a console command, but if you are not allowed to use the SDSF release command on your own job then I seriously doubt that you will be able to use console commands. In this case you will have to ask an operator to release your job.

Nic Clouston · Posted: Wed Mar 05, 2008 4:48 am Post subject:

or do not submit it until it is OK for it to run
_________________
Utility and Program control cards are NOT, repeat NOT, JCL.