MVSFORUMS.com

[princeofpersia2]

Hi Folks!

Transaction M900 starts program SBC0900.
Transaction TMDS starts program SBCP785.

Transaction MMCP also starts program SBCP785 and MMCP is used by several other programs (in other regions) to run SBCP785. One of these transacation/program is M900/SBC0900.


The program SBC0900 starts TMDS as follows -
EXEC CICS START
TRANSID ('TMDS')
FROM (SBMPF-RECORD)
RESP (CICS-RESPONSE)
END-EXEC

In SBCP785 (attached to TMDS txn), how can I make out whether the program was STARTed by M900/SBC0900 or another transaction/program (perhaps in another region)?

Also, the solution must take into consideration that only these two programs - SBC0900 & SBCP785 - be changed. No other program that STARTS MMCP/SBCP785 should be needed to be changed.

Besides M900/SBC0900, the other programs use the following command to start MMCP/SBCP785 -
EXEC CICS
START TRANSID ('MMCP')
FROM (SBMPF-RECORD)
END-EXEC

Any help most appreciated.

Thanks,
PrinceOfPersia2
_________________
Thanks,
princeofpersia2

[blitz2]

I think you are looking for EIBTRNID in DFHEIBLK.

http://www.mvsforums.com/helpboards/viewtopic.php?t=5675&highlight=eibtrnid
________
Ford Sierra

[kolusu]

princeofpersia2,

You will be Banned if you continue to post the same questions in multiple forums.

Kolusu
_________________
Kolusu
www.linkedin.com/in/kolusu